User Guide

PC2 Made Easy

2. Press Copy, then press the zone button for the zone you want to copy. Then press

Enter.

3. Press the MIDI Setups button. Select the Setup that you want to paste into.

4. Press the Copy button. Press the >> button, then press the Zone button for the zone

you want to paste into. Then press Enter.

To copy all the controller parameters from one controller to another:

1. Call up the Setup that has the controller data that you want to copy. Hold the

Controllers button and move the controller that you want to copy, to bring up the first

parameter for that particular controller. If you are not on the zone that has the controller

parameters you want to copy, press the zone button for the correct zone.

2. Press Copy, Enter.

3a. If you want to copy the data to the same controller but in a different zone, press the

appropriate Zone button, then press the >> button to get to the Paste parameter, then

Enter.

3b. If you want to copy the data to a different controller, hold the Controllers button

and move the new controller. You can also choose a different zone at this point by

pressing the appropriate zone button. (For example, you might want to copy all the

Zone 1, Slider A parameters to Zone 2, Slider B.) Press the Copy button, then the >>

button, then Enter.

3c. You can also copy the controller parameters into a different Setup. Press the MIDI

Setups button and select the Setup you want to paste into. Hold the Controllers button

and move the appropriate controller. Press the Zone button for the appropriate Zone.

Press the Copy button, then the >> button, then Enter.

It is important to keep in mind that you can only copy and paste into similar controllers

- the parameters for a switch controller can only go to another switch controller, and

those for a continuous controller can only go to another continuous controller.

To copy all the Arpeggiator parameters from one Setup to another:

1. Call up the Setup that has the arpeggiator data that you want to copy. Press the

Arpeggiator button.

2. Press Copy, Enter.

3. Press the MIDI Setups button. Select the Setup that you want to paste into. Press the

Arpeggiator button.

4. Press the Copy button. Press the >> button, then Enter.

You should be aware that this will only copy the parameters found within the

Arpeggiator menu. If you have any controllers assigned to function such as Arp Latch or

Arp Switch, they will not be copied.