User Guide

PC2 Made Easy
76
31. Selecting Setups from an External Controller
You can call up a Setup from an external controller or a sequencer, by sending a bank
controller and program change message on a specified channel. This would most
typically be done in a performance situation where you need to automate calling up
Setups.
1. First you need to choose a MIDI channel you will use to send the bank and program
change messages. A good rule of thumb is to dedicate a specific channel for this function
and not use that channel for sending any other MIDI info. Press the Global button, and
then press the >> button 5 times to get to Setup Chg Chan. Set this to the channel you
have chosen.
2. Press the MIDI Setups button. At this point, sending bank and program change
messages from your external controller on the specified channel will call up the
appropriate Setup.
There are a couple of things to be aware of.:
First, of all, MIDI Setups are displayed starting numbering at 1 instead of 0. Because of
this, there will be an offset of 1 in response to the standard program changes of 0-127.
To call up Setup number 1, send program change 0, to call up Setup number 2, send
program change 1.
Second, although the User Setups start numbering at 129, MIDI only has 128 values (0-
127). So the User Setups are actually in another bank. Sending the bank controller
(controller #32) with a value of 1 followed by program change 0 will call up Setup 129,
controller #32 with a value of 1 followed by program change 1 will call up Setup 130 etc.
If you need to quickly know which program change number to send when calling up a
User Setup, simply subtract 129 from the Setup number and you will know the correct
value for the program change message.
If no bank controller is sent, the PC2 will always revert to the first bank (the preset
Setups). If you ARE sending the bank controller and want to get to a preset Setup, you
would send controller #32 with a value of 0.