Specifications

Program Edit Mode
Program Pages
7-3
Program Pages
The parameters for each page in Program Edit Mode are explained in detail below.
PARAMS Page
Parameter Range Of Values Default Value
Parameter Program / Effect Chain dependent -
Control Physical controller or MIDI CC None
Value None, 0 to 127 None
Press the PARAMS soft button to display the Parameters page (see above.)
The Parameters page allows you to access all of the controllable parameters for the current
program. The parameters page will also display any available VAST synthesis parameters
for the current program and parameters for the current program’s insert and auxiliary 1&2
effects (if effects are in use.) All available parameters are listed. For each parameter you can
set a MIDI value as well as a control source.
The left column lists the available parameters, the center column shows the control source
(either a physical controller or MIDI CC number) which that parameter is controlled by, and
the right column shows the MIDI value for each parameter.
Parameter
Use the cursor buttons to select a parameter in the left column, and use the Alpha Wheel,
Value buttons, or cursor up/down buttons to scroll through parameters in that column.