Specifications
Troubleshooting
If None of the Above...
13-7
If None of the Above...
If your problem is not covered above, or if none of the suggestions seem to work, rst
check back and review the relevant sections of this manual. Many difculties are just
programming problems caused by settings of Multi parameters. If you want to be sure that
all of the factory defaults are in place, see Restoring Factory Defaults on page 11-7.
Also be sure to check Kurzweil’s website for additional Forte information that may have
been published since this manual was written: www.kurzweil.com.
If you still have problems, contact Kurzweil support in your country or at www.kurzweil.
com/support/. You may also nd unofcial help at some of the internet communities listed
at www.kurzweil.com/community/.
Service Centers
Contact the nearest Young Chang ofce Kurzweil service representative. See page vi in
the front of this manual for contact information.
Restoring Factory Defaults
For restoring your Forte back to the factory defaults, see Global Mode Reset on page 10-20
CAUTION: Restoring factory defaults cannot be undone. Back up
your files before doing so by following the procedure on page 12-5
Diagnostics
You will most likely not need to use the System Mode diagnostic operations in normal
cases. These operations are mostly used at the factory and service centers by engineers
for troubleshooting hardware problems. But, in some cases you might be required to run
these diagnostics for troubleshooting and diagnosing symptoms. In these cases, follow the
direction of an authorized Kurzweil technician.