Specifications

Program Edit Mode
Program Pages
7-9
COMMON Page
The Common Page allows adjustment of a number of general parameters for the program.
Parameter Range Of Values Default Value
BendRange Up -7200 cents to +7200 cents 200 ct
BendRange Down -7200 cents to +7200 cents -200 ct
Output Gain -96 to 24dB 0dB
Category None, 20 Categories None
BendRange Up & BendRange Down
Use these parameters to dene how much the pitch will change when you move the Pitch
Wheel. You can set either Bend parameter to bend by up to 72 half-steps up or down. Pitch
values are set in cents, where 100 cents = 1 half-step (1 semitone).
For both Bend parameters, positive values will cause the pitch to bend up, while negative
values will cause the pitch to bend down. Large positive values can cause samples to bend to
their maximum upward pitch shift before the Pitch Wheel is fully up (or down). This will not
happen when bending the pitch down.
Output Gain
Adjusts the output level of the currently selected program by up to -96 dB or +20 dB.