User Guide

FXAlg #964: Dual AutoPanner
Algorithm Reference-168
Parameters:
PAGE 1
PAGE 2
PAGE 3
In/Out
When set to ÒInÓ the auto-panner is active; when set to ÒOutÓ auto-panner is bypassed.
Out Gain The overall gain or amplitude at the output of the effect.
LFO Rate The speed of the panning motion.
Origin The axis for the panning motion. At 0%, panning excursion will be centered at the center
of the listening speakers. Positive values shift the axis to the right, while negative values
shift it to the left. At -100% or +100%, there is no room for panning excursion.
Pan Width The amount of auto pan excursion. This value represents the percentage of total panning
motion available after Origin is set.
CentrAtten Amount the signal level is dropped as it is panned through the center of the listening
stereo speaker array. For the smoothest tracking, a widely accepted subjective reference
is -3dB. Values above -3dB will cause somewhat of a bump in level as an image passes
through the center. Values below -3dB will cause a dip in level at the center.
LFO Shape The waveform type for the LFO. Choices are Sine, Saw+, Saw-, Pulse, Tri, and Expon.
PulseWidth When the LFO Shape is set to Pulse, this parameter sets the pulse width as a percentage
of the waveform period. The pulse is a square wave when the width is set to 50%. This
parameter is active only when the Pulse waveform is selected.
L In/Out In or Out R In/Out In or Out
L Out Gain Off, -79.0 to 24.0 dB R Out Gain Off, -79.0 to 24.0 dB
L LFO Rate 0 to 10.00 Hz L LFO Shape Tri
L RateScal 1 to 25088 x L PlseWdth 0 to 100%
L Origin -100 to 100%
L PanWidth 0 to 100%
L CentrAtt 0 to 100% L
L C R
R LFO Rate 0 to 10.00 Hz R LFO Shape Tri
R RateScal 1 to 25088 x R PlseWdth 0 to 100%
R Origin -100 to 100%
R PanWidth 0 to 100%
R CentrAtt 0 to 100% R
L C R