User Guide

FXAlgs #961/962: Tremolo and Tremolo BPM
Algorithm Reference-163
Parameters (Tremolo):
PAGE 1
PAGE 2
Parameters (Tremolo BPM):
PAGE 1
PAGE 2
In/Out When set to ÒInÓ the effect is active; when set to ÒOutÓ the effect is bypassed.
Out Gain The overall gain or amplitude at the output of the effect.
Tempo (Tremolo BPM) Basis for the rate of the LFO, as referenced to a musical tempo in BPM (beats per
minute). When this parameter is set to ÒSystemÓ, the tempo is locked to the internal
sequencer tempo or to incoming MIDI clocks. When it is set to ÒSystemÓ, sources (FUNs,
LFOs, ASRs etc.) will have no effect on the Tempo parameter.
LFO Rate (Tremolo) The speed of the tremolo LFO in cycles per second.
LFO Rate (Tremolo BPM) The number of LFO cycles in one beat relative to the selected Tempo. For example, 1.00x
means the LFO repeats once per beat; 2.00x twice per beat; etc...
Rate Scale (Tremolo) This multiplies the speed of the LFO rate into the audio range. When above 19x, the
values increment in semitone steps. These steps are accurate when LFO Rate is set to
1.00 Hz.
LFO Phase (Tremolo BPM) This parameter shifts the phase of the tremolo LFO relative to an internal beat
reference. It is most useful when Tempo is set to ÒSystemÓ and LFO Phase controls the
phase of the LFO relative to MIDI clock.
Depth This controls the amount of attenuation applied when the LFO is at its deepest excursion
point.
LFO Shape The waveform type for the LFO. Choices are Sine, Saw+, Saw-, Pulse, Tri, and Expon.
In/Out In or Out Out Gain Off, -79.0 to 24.0 dB
LFO Rate 0 to 10.00 Hz LFO Shape Tri
Rate Scale 1 to 25088 x PulseWidth 0 to 100%
Depth 0 to 100% 50% Weight -6 to 3 dB
L/R Phase In or Out
A
0% 50% 100%
In/Out In or Out Out Gain Off, -79.0 to 24.0 dB
Tempo System, 0 to 255 BPM
LFO Rate 0 to 12.00 x LFO Shape Tri
LFO Phase 0.0 to 360.0 deg PulseWidth 0 to 100%
Depth 0 to 100% 50% Weight -6 to 3 dB
L/R Phase In or Out
A
0% 50% 100%