User Guide

FXAlg #911: Mono LaserVerb ¥ FXAlg #912: LaserVerb Lite ¥ FXAlg #913: LaserVerb
Algorithm Reference-137
The output from LaserVerb can be fed back to the input. By turning up the feedback, the duration of the LaserVerb
sound can be greatly extended. Cross-coupling may also be used to move the signal between left and right channels,
producing a left/right ping-pong effect at the most extreme settings.
The 2-PAU version is a sparser version than the 3-PAU version. Its buzzing is somewhat coarser. The 1-PAU version
is like the 2-PAU version except the two input channels are summed and run through a single mono LaserVerb. The
1-PAU version does not have the cross-coupling control but does have output panning.
LaserVerb
Parameters:
PAGE 1 - LaserVerb and LaserVerb Lite
PAGE 1 - Mono LaserVerb
PAGE 2
Wet/Dry The amount of reverbed (wet) signal relative to unaffected (dry) signal.
Out Gain The overall gain or amplitude at the output of the effect.
Wet/Dry 0 to 100%wet Out Gain Off, -79.0 to 24.0dB
Fdbk Lvl 0 to 100%
Xcouple 0 to 100%
HF Damping 16 to 25088Hz
Wet/Dry 0 to 100%wet Out Gain Off, -79.0 to 24.0dB
Fdbk Lvl 0 to 100% Pan -100 to 100%
HF Damping 16 to 25088Hz
Dly Coarse 0 to 5000ms Contour 0.0 to 100.0%
Dly Fine -20.0 to 20.0ms
Spacing 0.0 to 40.0samp
LaserVerb
From Right
Channel
To Right
Channel
Dry
Feedback
Wet
L OutputL Input