User Guide

FXAlg #907: Ring Modulator
Algorithm Reference-128
Configurable Wave Shapes (Osc1 only)
Parameters:
PAGE 1
PAGE 2
PAGE 3
Wet/Dry The amount of modulated (wet) signal relative to unaffected (dry) signal as a percent.
When in ÒL*RÓ mode, the left input will be used as the dry signal.
Out Gain The overall gain or amplitude at the output of the effect.
Mod Mode Switches between the two operating modes of the algorithm. The ÒL*RÓ mode treats the
left and right inputs as the modulator and carrier signals. It does not matter which input
is left and which is right except to note that only the left signal will be passed through as
dry.
L*R Pan The output panning of the both wet and dry signals. This control is active only in ÒL*RÓ
mode. -100% is panned fully left, 0% is panned center and 100% is panned right.
Osc1 Lvl The level of the conÞgurable oscillator. 0% is off and 100% is maximum. This parameter
is active only in ÒOscÓ mode.
Osc1 Freq The fundamental frequency of the conÞgurable oscillator. The oscillators can be set
through the audible frequencies 16-25088 Hz with 1 semitone resolution. This parameter
is active only in ÒOscÓ mode.
Osc1Shape Shape selects the waveform type for the conÞgurable oscillator. Choices are Sine, Saw+,
Saw-, Pulse, Tri, and Expon. This parameter is active only in ÒOscÓ mode.
Wet/Dry 0 to 100%wet Out Gain Off, -79.0 to 24.0 dB
Mod Mode L*R or Osc L*R Gain Off, -79.0 to 48.0 dB
L*R Pan -100 to 100%
Osc1 Lvl 0 to 100% Osc1 Freq 16 to 25088 Hz
Osc1 Shape Sine
Osc1PlsWid 0 to 100%
Osc1Smooth 0 to 100%
Sine2 Lvl 0 to 100% Sine2 Freq 16 to 25088 Hz
Sine3 Lvl 0 to 100% Sine3 Freq 16 to 25088 Hz
Sine4 Lvl 0 to 100% Sine4 Freq 16 to 25088 Hz
Sine5 Lvl 0 to 100% Sine5 Freq 16 to 25088 Hz
Sine Saw+ Saw- Puls
e
Tri Expon
PulseWidth