User Guide

FXAlg #735/6: KB3 FX
Algorithm Reference-115
Parameters (KB3 AuxFX):
PAGE 1
PAGE 2
PAGE 3
PAGE 4
In/Out When set to ÒInÓ, the algorithm is active; when set to ÒOffÓ the algorithm is bypassed.
For the entire algorithm to be active, KB3 FXBus must also be active with its Roto InOut
parameter set to ÒInÓ. To completely bypass the rotary, one or both of the In/Out or Roto
InOut parameters in KB3 FXBus must also be bypassed.
Out Gain The overall gain or amplitude at the output of the effect.
Lo Gain The gain or amplitude of the signal passing through the rotating woofer (low frequency
driver. The control is also available in KB3 FXBus.
Hi Gain The gain or amplitude of the signal passing through the rotating tweeter (high frequency
driver. The control is also available in KB3 FXBus.
For details on the rest of the parameters see the section of this book on FXAlg #733.
In/Out In or Out Out Gain Off, -79.0 to 24.0 dB
Lo Gain Off, -79.0 to 24.0 dB Hi Gain Off, -79.0 to 24.0 dB
Lo Rate -10.00 to 10.00 Hz Hi Rate -10.00 to 10.00 Hz
Lo Size 0 to 250 mm Hi Size 0 to 250 mm
Lo Trem 0 to 100% Hi Trem 0 to 100%
Lo Beam W 45.0 to 360.0 deg Hi Beam W 45.0 to 360.0 deg
LoMicA Pos -180.0 to 180.0 deg LoMicB Pos -180.0 to 180.0 deg
LoMicA Lvl 0 to 100% LoMicB Lvl 0 to 100%
LoMicA Pan -100 to 100% LoMicB Pan -100 to 100%
HiMicA Pos -180.0 to 180.0 deg HiMicB Pos -180.0 to 180.0 deg
HiMicA Lvl 0 to 100% HiMicB Lvl 0 to 100%
HiMicA Pan -100 to 100% HiMicB Pan -100 to 100%
LoResonate 0 to 100% HiResonate 0 to 100%
Lo Res Dly 10 to 2550 samp Hi Res Dly 10 to 2550 samp
LoResXcurs 0 to 510 samp HiResXcurs 0 to 510 samp
ResH/LPhs 0.0 to 360.0 deg