User Guide

FXAlg #733: VibChor+Rotor 2 ¥ FXAlg #734: VibChor+Rotor 4
Algorithm Reference-108
Parameters:
PAGE 1
PAGE 2
PAGE 3
PAGE 4
In/Out
When set to ÒInÓ, the algorithm is active; when set to ÒOutÓ the algorithm is bypassed.
Out Gain The overall gain or amplitude at the output of the effect. For distortion, it is often
necessary to turn the output gain down as the distortion drive is turned up.
VibChInOut When set to ÒInÓ the vibrato/chorus is active; when set to ÒOutÓ the vibrato/chorus is
bypassed.
Vib/Chor This control sets the Hammond B3¨ vibrato/chorus. There are six settings for this effect:
three vibratos ÒV1Ó, ÒV2Ó, ÒV3Ó, and three choruses ÒC1Ó, ÒC2Ó, ÒC3Ó
Roto InOut When set to ÒInÓ the rotary speaker is active; when set to ÒOutÓ the rotary speaker is
bypassed.
Dist Drive Applies a boost to the input signal to overdrive the distortion algorithm. When
overdriven, the distortion algorithm will soft-clip the signal. Since distortion drive will
make your signal very loud, you may have to reduce the Out Gain as the drive is
increased. [VibChor+Rotor 4 only]
In/Out In or Out Out Gain Off, -79.0 to 24.0 dB
VibChInOut In or Out Dist Drive 0 to 96 dB
Vib/Chor V1 DistWarmth 16 to 25088 Hz
Roto InOut In or Out Cabinet LP 16 to 25088 Hz
Xover 16 to 25088 Hz
Lo Gain Off, -79.0 to 24.0 dB Hi Gain Off, -79.0 to 24.0 dB
Lo Rate -10.00 to 10.00 Hz Hi Rate -10.00 to 10.00 Hz
Lo Size 0 to 250 mm Hi Size 0 to 250 mm
Lo Trem 0 to 100% Hi Trem 0 to 100%
Lo Beam W 45.0 to 360.0 deg Hi Beam W 45.0 to 360.0 deg
LoMicA Pos -180.0 to 180.0 deg LoMicB Pos -180.0 to 180.0 deg
LoMicA Lvl 0 to 100% LoMicB Lvl 0 to 100%
LoMicA Pan -100 to 100% LoMicB Pan -100 to 100%
HiMicA Pos -180.0 to 180.0 deg HiMicB Pos -180.0 to 180.0 deg
HiMicA Lvl 0 to 100% HiMicB Lvl 0 to 100%
HiMicA Pan -100 to 100% HiMicB Pan -100 to 100%
LoResonate 0 to 100% HiResonate 0 to 100%
Lo Res Dly 10 to 2550 samp Hi Res Dly 10 to 2550 samp
LoResXcurs 0 to 510 samp HiResXcurs 0 to 510 samp
ResH/LPhase 0.0 to 360.0 deg