User Manual

Multi Mode
The Layer Function
7-9
Initially the last used Split Program will be selected, or the default Split Program (210
Motown Bass) if this is the rst time using the Split Function since power-up. Choose a Split
Program using the Category and Program/Multi buttons, the Alpha Wheel, or the Previous/
Next buttons.
Vol (Split Volume)
Press the VOLUME soft button to change the Vol (Split Volume) parameter. This parameter
determines the volumes of the left and right-hand Zones. By default, the Split Volume is
set to 0, which results in all Zones having the same volume. When set to a positive number,
the volume for the right hand Zone(s) is decreased. When set to a negative number, the
volume for the left hand Zone(s) is decreased. To set the Split Volume, use the Alpha Wheel,
Previous/Next buttons, or enter a number using the numbers printed on the Program/
Multi buttons followed by pressing the Enter button. Split Volume can be set to any number
between -127 and 127.
Pressing the Value Jump button pair (Previous & Next) resets the volume to 0.
Key (Split Key)
Press the KEY soft button to change the Key (Split Key) parameter. This parameter sets
the keyboard key that will be the boundary between the left and right hand Zones on the
keyboard. The selected key will be the highest note for the left-hand Split Program. All keys
higher than the Split Key will play the right-hand Zone(s). By default, the Split Key is set to
B3. The Split Key can be selected using Assign
, by holding down the Enter button and
then striking the desired key on the keyboard. The Split Key can also be selected by using the
Alpha Wheel, Previous/Next buttons, or by entering a number using the numbers printed
on the Program/Multi buttons. Split Key can be set to any key between A0 and C8.
Transpose (Split Transposition)
Press the XPOSE soft button to change the Transpose (Split Transposition) parameter.
This parameter allows you to transpose the left-hand Split Program in octaves so that you
can play it in higher or lower octaves. Use the Alpha Wheel or Previous/Next buttons to
set the Transpose value. Transpose can be set to -24, -12, 0, 12, and 24. By default, Split
Transposition is set to +12.
Saving a Split
After setting the Split parameters, press the Save button to the left of the display to begin
the saving process. See Save & Delete User Multis (page 7-12) for details on saving. Once
you have saved your Split, you can continue to add Split or Layer Zones to the Multi until
you reach the maximum of four active Zones. Also, once you have saved your Split, you can
edit controller assignments and other Multi parameters in Multi Edit Mode (see Multi Edit
Mode on page 8-1 for details).