User Manual

Program Mode
Save & Delete User Programs
6-19
To change the ID number press the ID soft button, turn the Alpha Wheel or use the Value
buttons to select the new ID number. You can also use the Category and Program/Multi
buttons to select an ID number, which is useful for organizing user Programs by Category.
To do this, rst select a Category button, then select a Program/Multi button to select an ID
within that category.
Naming a User Program
To rename the Program, rst press the Name soft button. You should see the following in
the display:
The display shows the current Program name. Program names can total 16 characters in
length. Use the letters and numbers printed on the Program/Multi buttons to enter the new
Program name.
Press the Previous or Next button to move the cursor. Press the +/- button to switch
between upper and lower case characters (all characters will be upper case until you press the
+/- button again).
Use the Space button to change the current character to a space, the Insert button to insert a
blank space (the selected character and all characters to the right will move one space to the
right), and the Delete button to delete the current character (all the characters to the right
will move one space to the left).