User Manual

Multi Edit Mode
Zone Parameters
8-20
Controlling Program Parameter Assignments from Multi Mode
Commonly you will want to assign a physical controller in a Multi to control the
same Program parameter that it controlled in Program Mode. In the Dest parameter
list, destinations that are assigned to parameters for the Program of the current
Zone will show the Program Parameter name to the right of the Destination Name.
Select one of these destinations to control an assigned Program parameter
Controller
Number
Controller
Destination
Description
0 OFF/Bank
By default, when you enter 0 or Clear for the Destination parameter, the
destination will be assigned to OFF. To select Bank as the destination, use
the Value buttons.
1 MWheel
Default destination for the Modulation Wheel
2 Breath
Default assignment for breath controller in compatible synths
3 MIDI 03
MIDI Controller 3
4 Foot
Default assignment for continuous foot controller in compatible synths
5 PortTim
Monophonic Artis Programs respond to this Controller if portamento is
turned on.
6 Data
MIDI Controller 6
7 Volume
MIDI Volume
8 Balance
MIDI Balance
9 MIDI 09
MIDI Controller 9
10 Pan
MIDI Pan
11 Express
Default assignment for CC Pedal. In most Programs it acts as a volume
control. It scales between 0 and the current value of Volume.
12 MIDI 12
Default assignment for Slider A
13 MIDI 13
Default assignment for Slider B
14-21 MIDI 14-21
MIDI Controllers 14-21
22 MIDI 22
Default assignment for Slider C
23 MIDI 23
Default assignment for Slider D
24 MIDI 24
Default assignment for Slider E
25 MIDI 25
Default assignment for Slider F
26 MIDI 26
Default assignment for Slider G
27 MIDI 27
Default assignment for Slider H
28 MIDI 28
Default assignment for Slider I
29 MIDI 29
Default assignment for Variation switch
30-31 MIDI 30-31
MIDI Controllers 30–31