User Manual

Multi Edit Mode
Zone Parameters
8-10
KEYS Page
Parameter Range Of Values Default Value
Transpose -128 to 127 ST 0
Low Key C-1 to G9 C-1
High Key C-1 to G9 G9
Low Velocity 1 to 127 1
High Velocity 1 to 127 127
Note Map Off, Linear, Constant Linear
Transpose
The Transpose parameter determines the transposition for the currently selected Zone. You
can set this to any value from -128 semitones to 127 semitones.
Pressing both Previous & Next buttons simultaneously will set this parameter to 0.
Low Key
The Low Key parameter determines the lower boundary of the currently selected Zone.
You can set this parameter to any note from C-1 to G9. Pressing both Value buttons
simultaneously will set this parameter to C-1.
If, for example, you set Low Key to C4, then only keys at or above C4 will trigger a note for
the currently selected Zone. Keys below C4 will not trigger a note.
Pressing both Previous & Next buttons simultaneously will set this parameter to C-1.
High Key
The High Key parameter determines the higher boundary of the currently selected Zone.
You can set this parameter to any note from C-1 to G9.
If, for example, you set High Key to C4, then only keys at or below C4 will trigger a note for
the currently selected Zone. Keys above C4 will not trigger a note.