User Manual
Multi Mode
Save User Multis
10-12
of “None” will use the last pan value used by the Zone’s MIDI channel. A value of “None”
can be entered by scrolling below 0, or by using the keypad function of the Category buttons
to type negative 1 by pressing the +/- button and then the 1 button, followed by the Enter
button.
Saving a Split or Layer
After setting the Split parameters, press the Save button to the left of the display to begin
the saving process. A Multi name is automatically created using half of the Zone 1 Program
name and half of the Zone 2 Program name. is name can be edited during the saving
process. See Save User Multis below for details on saving.
Once you have saved your Split or Layer, you can continue to add Zones to the Multi until
you reach the maximum number of active Zones. Also, once you have saved your Split, you
can use Multi Edit Mode to edit controller assignments (like eects controls and sustain
pedal per Zone), transposition per Zone, and other Multi parameters. (See Multi Edit Mode
on page 11-1 for details.)
Save User Multis
To save changes to the current User Multi, or to save a changed Factory Multi to a User
Category, press the Save button once.