User Manual

Keymap and Sample Editing
The Keymap Editor
9-7
Velocity Ranges (VelRng)
Press the VELRNG soft buttonto view the VEL RANGES page. Use the VEL RANGES
page to add, edit or delete velocity ranges for the current keymap. e VEL RANGES page
shows a chart of a keymap’s entire available dynamic range, from most quiet (ppp) to most
loud (f). Velocity ranges can also be adjusted from the Edit Keymap page, but the VEL
RANGES page provides a chart as a visual aid. Each keymap can be split into a maximum
of eight velocity ranges. Each key range in a keymap can use its own sample for each velocity
range. All key ranges in a keymap share the same velocity ranges.
Press the Split soft button to split the currently selected velocity range into two ranges (until
the maximum of eight velocity ranges have been created). Press the Delete soft button to
delete the currently selected velocity range. Press the Exit soft button to return to the Edit
Keymap page.
On the VEL RANGES page, the currently selected velocity range is highlighted in the chart,
and its name is displayed in the VelRange eld. With the VelRange eld selected, you can
use the Alpha Wheel or Previous-/Next+ buttons to move between the available velocity
ranges (if there is more than one velocity range available). You can also use the Channel/
Zone buttons at any time to move between the available velocity ranges. If there is more
than one velocity range available, you can adjust the dynamic range of each using Lo and
Hi parameters. ese Hi and Lo parameters are the same as the Low Velocity (Lo) and High
Velocity (Hi) parameters on the Edit Keymap page (see Low Velocity (Lo), High Velocity
(Hi) for details). Changes made with either set of parameters are shown on both pages.
New Range (NewRng)
e NEWRNG soft button lets you dene a new keyrange to edit, whether it’s to assign a
dierent sample, or to adjust the pitch or volume. Just press NEWRNG, then play the note
you want as the low note, then the high note. e Forte will prompt you for each note.
When you trigger the high note, you’ll return to the Keymap-editor page, and the new
keyrange you dened will be selected. e next change you make will aect only that edit
range.
If you set a new keyrange that’s completely within an existing key range, the existing key
range will be split into two keyranges, with the new keyrange between the two. At this
point, you must change at least one parameter of the new keyrange before editing a dierent
keyrange, otherwise the new keyrange will be merged with the adjacent keyranges. If you
set a new keyrange that overlaps part or all of another key range, the sample assigned to the
lower key range will be applied to the new keyrange. Again, at this point you must change
at least one parameter of the new keyrange before editing a dierent keyrange, otherwise the
new keyrange will be merged with the lower keyrange that it overlapped.
Assign
e ASSIGN soft button lets you select a sample, then specify the key range to which it’s
assigned. is enables you to insert a new key range within the current keymap. When you
press the ASSIGN soft button, a dialog appears that prompts you to select a sample from the
Samples list. Scroll through the list, then press the OK soft button. You’ll then be prompted