User Manual
Program Edit Mode
KB3 Editor: The PERC Page
7-91
ReTrigThresh
is parameter lets you set the volume level below which key click must decay before it will
be retriggered.
Note Attack
Controls the attack characteristic of notes. Normal provides a smoothed attack, while a
setting of Hard has an instant attack and will produce an audible click, in addition to any
amount of key click specied with the other parameters on this page (you might prefer not to
specify any additional key click when you use this setting). PercHard sets a hard attack level
for percussion only; notes without percussion use a normal attack.
Note Release
Controls the release characteristic of notes. A setting of Normal has a smoothed release, while
a setting of Hard has an instant release. Hard will produce an audible click.
Key and Key Track Amount
e Key and Key Track Amount parameters are used to scale the volume of the key click
based on each note played, to make the key click volume lower for lower keys. e Key
parameter sets the key at at which scaling will begin. All notes below the selected key will
scale the key click volume based on the setting of the Key Track Amount parameter. e
Key Track Amount parameter is used to control the rate at which the key click volume will
change below the selected key.
KB3 Editor: The PERC Page
Percussion is a characteristic feature of tone wheel organs. It’s especially useful while soloing,
since percussion adds an extra “plink” (actually an extra tone at a dened harmonic) to the
attack. You can reach the percussion parameters by pressing the PERC soft buttons.