User Manual

Program Edit Mode
KB3 Editor: The KEYCLICK Page
7-90
KeyClick Parameters
Parameter Range of Values
Key Click Off, On
Volume -96.0 to 0.0 dB, in 0.5-dB increments
Decay 0.005 to 1.280 seconds, in 0.005-second increments
Velocity Trk 0 to 100%
Pitch 1 to 120
Key B3
Random 0 to 100%
Retrig Thresh -96.0 to 0.0 dB, in 0.5-dB increments
Note Attack Normal, Hard, PercHard
Note Release Normal, Hard
Key Track Amount -10% - 0%/key
KeyClick
is is where you turn Key Click on or o. With KeyClick set to O, you may still hear a
click depending on your Note Attack and Note Release settings (see below).
Volume
is parameter sets the level of the keyclick; the noise decays from the level you set here. is
level is scaled by the drawbar levels, as well as the expression pedal level.
Decay
Sets the basic decay time of the noise envelope. Smaller values produce a shorter burst.
Velocity Track
Controls the degree to which key velocity aects the key click volume. A value of zero means
that the key velocity has no eect on the key click volume (which is like a real tone wheel
organ). Other values add volume as the velocity increases. is parameter typically only
applies when playing a KB3 program from an external MIDI device.
Pitch
Sets the basic pitch of the key click noise, relative to the highest tonewheel’s pitch. e pitch
is controlled by a steep lowpass lter applied to white noise. e lter’s cut o frequency
is controlled relative to key number, higher keys move the cuto frequency up, lower keys
move the cuto frequency down.
Random
Controls the degree to which a random amount of amplitude variation is added to the key
click.