User Manual

Program Edit Mode
KB3 Editor: The PITCH Page
7-88
Volume
Use the Volume parameter to set the preset volume of each of the nine drawbars. e
available values will be
0–8 or 0–127, depending on the setting of the Steps parameter.
Tune
is parameter lets you tune each of the nine drawbars up or down in semitone steps. e
values for the Tune parameter on the DRAWBR page shown above represent standard
drawbar settings on a real B3, as shown in the table below.
Subharmonics Fundamental Harmonics
16’ 5
1
/3’ 8’ 4’ 2
2
/3’ 2’ 1
3
/5’ 1
1
/3’ 1’
Slider A Slider B Slider C Slider D Slider E Slider F Slider G Slider H Slider I
Figure 7-2 Standard Drawbar Settings for the Hammond B3
KB3 Editor: The PITCH Page
e PITCH page parameters for KB3 programs are much like the Pitch parameters for VAST
programs on the DSPMOD page. e only dierence is that for KB3 programs, there are
no Hz, KeyTrk, or VelTrk parameters. For a full description of the PITCH-page parameters,
see Common DSP Control Parameters, The DSP Control (DSPCTL) Page and The DSP
Modulation (DSPMOD) Page.