User Manual

Program Edit Mode
The DSP Modulation (DSPMOD) Page
7-42
DSP Control Page Parameters
Function Parameter Range of Values Default
Pitch
Pitch -128 to 127 semitones 0
Fine Adjust ± 100 cents 0
Hertz Adjust ± 10.00 Hertz 0
Key Tracking ± 2400 cents/key 0
Velocity Tracking ± 7200 cents 0
(Function) (Function-Parameter) (Depends on Function) (Depends on Function)
(Function) (Function-Parameter) (Depends on Function) (Depends on Function)
(Function) (Function-Parameter) (Depends on Function) (Depends on Function)
(Function) (Function-Parameter) (Depends on Function) (Depends on Function)
Level
Level -96 to 24 decibels -6
Key Tracking ± 2.00 decibels/key 0
Velocity Tracking ± 96 decibels 35
Each eld in the left-hand column of the page is a function-parameter of the current layer’s
algorithm. You can coarsely adjust the function-parameter in these left-hand elds—as noted
in Common DSP Control Parameters, any adjustments made to the function-parameters on
the DSPCTL page are reected in the corresponding function-parameters on the DSPMOD
page. e right-hand side of the DSPCTL page is the subpage of the highlighted function-
parameter—on the subpage are the ne adjust parameters and hard-wired parameters. To
access the parameters on the subpage, highlight the function-parameter you wish to edit,
and then press the > button to move the cursor into the subpage.e label of a function-
parameter depends on its corresponding function-block in the current layer’s algorithm.