User Manual

Program Edit Mode
The COMMON Page
7-22
Parameter Range Of Values Default Value
Out Pan -64 to +64 0
Out Pan Mode +Midi, Fixed +Midi
Global On, Off On
Demo Song Demo Song list 0 None
Out Pan, and Out Pan Mode
e Out Pan and Out Pan Mode parameters allow you to adjust the panning of the programs
post-FX signal. Use the OutPan parameter to pan the signal; negative values pan the audio
signal to the left channel, positive values to the right, and a value of zero pans to the center.
When the OPanMode is set to Fixed the pan position remains as dened with the OutPan
parameter, ignoring MIDI pan messages. When the OPanMode is set to +MIDI, MIDI pan
messages (MIDI 10) will shift the sound to the left or right of the Pan parameter setting.
Message values below 64 shift it left, while those above 64 shift it right.
Globals
is parameter aects LFO2, ASR2, FUNs 2 and 4. When o, these three control sources
are local; they aect each individual note in the layers that use them as a control source. ey
begin operating each time a note in that layer is triggered.
When the Globals parameter is set to On, these control sources become global, that is
they aect every note in every layer of the current program, they’re not specic to any one
layer. When these control sources are global, they begin operating as soon as the program is
selected. When Globals are on, LFO2, ASR2, and FUNs 2 and 4 will appear on the LFO+
page preceded by the letter G to indicate that they’re global.
You’ll use global control sources when you want to aect all notes in a program uniformly,
and local control sources when you want to aect each note independently. For example,
you’d use a global LFO controlling pitch to create a Leslie eect on an organ sound, since you
want the eect applied to all the notes you play. You’d use a local LFO controlling pitch to
create a vibrato for a solo violin, since you want to be able to vary the rate and depth of the
vibrato for each note.
Demo Song
e Demo Song parameter allows you to choose the demo song for the current program.
e demo song is a short, preprogrammed song that gives you a demonstration of the
program in a musical context. You can play a program’s demo song in Program mode by
simultaneously pressing the Voices and Mallets Category buttons.