User Manual

System Mode
Run Diagnostics
10-3
6. To select Update, press the Next button once. The display shows
. Copy the le to the SP5 removable disk/drive on your
computer. Once copied, “Safely Remove” or “Unmount” the removable disk/drive from
your computer.
7. Press the Next button on the SP5. If the .KUF le is valid, the SP5 will display the
message . This will take a minute or two.
8. Once you see a message, power cycle the unit or press the Previous button to
return to the System Mode main menu.
Restore
Whenever you update the SP5’s software, a backup of the currently installed software is
made. This is in case of a need to revert back to the old software, such as if the new update
has problems or for troubleshooting.
NOTE: Only the previously installed version of the software is backed up. When you
perform a operation again, the current version is backed up. So, it’s possible to go
back and forth between versions.
Unlike the Update operation, the Restore operation can be performed without a computer
connected to the SP5:
1. Follow the instructions specied on page 10-1 to enter System Mode.
2. Press the Chan / Param Up (
̂
) button once. The display shows .
3. Press the Next button once. The display shows .
4. Press the Chan / Param Up (
̂
) button again. This display shows .
5. Press the Next button to restore the previous software version.
6. Press the Previous button to cancel and return to the System Mode main menu.
Run Diagnostics
You will most likely not need to use the Run Diagnostics operations in normal cases.
These operations are mostly used at the factory and service centers by engineers for
troubleshooting hardware problems. But, in some cases you might be required to run these
diagnostics for troubleshooting and diagnosing symptoms. In these cases, following the
direction of an authorized Kurzweil technician.