User Manual
System Mode
System Mode Buttons
10-2
System Mode Buttons
The Value and Chan/Param buttons perform the following functions in System Mode:
Previous Use the Previous button to return to the previous
menu. Similar to a “cancel” button.
Next Use the Next button to conrm a selection and move
into sub-menu if any. Like an “OK” button.
Chan / Param Up Use the Chan / Param Up button to select the next
menu item, menu item parameter or read Diagnostic test
messages.
Chan / Param Down Use the Chan / Param Down button to select the
previous menu item, menu item parameter or read
Diagnostic test messages.
Run SP5
This is the rst System Mode menu item. Pressing the Next button will load the OS and the
SP5 will start up as if you just switched on the unit (except for the message that
happens when you rst start up the unit).
Update Software
Update Software has two parameters: Update and Restore. Select Update to install a new OS
and Objects version, or select Restore to the install the previous OS version. The new OS
and Object les are combined in one le (.KUF).
Update
1. Obtain the Update le from the Kurzweil website or another reliable source and save it
in a known folder or directory on your computer.
2. Connect the SP5 (powered off) to your computer with a USB cable.
3. Follow the instructions specied on page 10-1 to enter System Mode. The SP5 will
appear as a removable disk/drive on your computer.
4. Press the Chan / Param Up (
̂
) button once. The display shows .
5. Press the Next button once. The display shows .