User Manual

Global Mode
The Global Parameters
9-9
The Load (Fill)? Dialog
NOTE: If the SP5 is currently connected to your computer as a MIDI controller, eject or
Safely Remove it before continuing. Selecting the Load (Fill) Dialog will disconnect any
MIDI device connected via USB.
The dialog allows you to load a le containing previously saved User Programs
and User Setups from a computer connected to the unit via USB. The loaded User Programs
and User Setups will ll any available location.
With the SP5’s power off, connect a USB cable from a computer to the USB port on the
SP5’s rear panel. Power-up the SP5, press the Global button, then select the
dialog.
Press the Next button–the display will show the message and the
SP5 will appear as a removable disk/drive on your computer. Copy the file, containing
your previously saved User Programs and User Setups, from your computer into the
SP5 removable disk/drive. Pressing the Next button will load the le, the display shows
, when complete .
Pressing the Previous button will cancel the load operation and recall the
dialog.
If no le is in the SP5 temporary drive during the load or an error occurs during the
load operation, then the display will show the error message, and a message
specifying the reason for the error.
If the SP5 is not connected to a computer, the display will show the error message
. Pressing the Previous button will recall the Load (Fill)? dialog—pressing the
Next button will retry to connect.