User Manual

Edit Setup Mode
The Zone-specic Parameters
8-14
Controller
Number
Controller
Destination
Description
139 SetupInc Setup Increment—increments current Setup number.
140 SetupDec Setup Decrement—increments current Setup number.
141 SetpGoto Go to Setup—selects Setup.
145 TransUp Transpose Up (ST)
146 TransDown Transpose Down (ST)
Entry Value
The Entry Value parameter determines the value of the continuous controller that is sent
as a MIDI message when the current Setup is loaded. You can set this parameter to any
number between 0 and 127, or to None. Pressing both Value buttons simultaneously will set
this parameter to None. None is -1.
If Entry Value is set to None, when you load the current Setup, the controller will be at
whatever value corresponds to its current position. If you specify an Entry Value, then a
MIDI controller message with this value will be sent when you load the current Setup.
Exit Value
The Exit Value parameter determines the value of the continuous controller that is sent as a
MIDI message when the current Setup is exited. You can set this parameter to any number
between 0 and 127, or to None. Pressing both Value buttons simultaneously will set this
parameter to None. None is -1.
If Exit Value is set to None, then when you leave the current Setup, the controller will be
at whatever value corresponds to its current position. If you specify an Exit Value, then a
MIDI controller message with this value will be sent when you close the current Setup.
The Foot Switch & Sw Button Parameters
• FtSw
• FtSw2
• Sw Button
The following are parameters that affect the behavior of the Foot Switch and Sw button
controller:
Mode
The Mode parameter determines the switching action of the Foot Switch. You can set this
parameter either of three settings:
Momentary A momentary switch is one that is only in the “on” state when it is
pressed. As soon as you release the switch, it goes into the “off ” state.