User Manual

Tutorials
Creating a Setup from a Program
11-5
2. Press the Layer Function button. This creates a Setup with two active Zones with
the same keyboard regions—i.e., overlapping keyboard regions. In this case, Program
125 Real Vibes as the Primary Voice. The Secondary Voice will be the last used Layer
Program or the default Program (ID number 634 Add a Pad 2) if this is the rst time
your using the Layer Function since power-up.
Note that as soon as we press the Layer Function button, the display shows the
Secondary Voice and the Save button illuminates. This simply indicates that a change
has been made. The Save button will be involved in the nal step of this process.
3. Let’s now change the Layer Program. Recall that the Layer Program determines the
Program for the Secondary Voice. The gure below shows the default Program as the
Secondary Voice:
4. Use the Alpha Wheel the Value buttons, or the alphanumeric data entry buttons (see
the Note on page 11-2.) to select the Secondary Voice. For our example, let’s choose
Program 423 Solo Flute for the Layer Program. The following gure illustrates our
current Layer Setup:
5. Let’s now change the Layer Volume. Recall that the Layer Volume determines
the relative volumes of the two Voices: positive values increase the volume of the
Secondary Voice and decrease the volume of the Primary Voice. Negative values
decrease the volume of the Secondary Voice and increase the volume of the Primary
Voice.
First, use the Chan / Param buttons to select the Layer Volume parameter. Then, use
the Value buttons to set the Layer Volume. For our example, since we want our vibes
to be slightly louder than our ute, let’s set this parameter to -20.
634 Add a
Pad 2*
Secondary Voice
125 Real Vibes
Secondary Voice
(*Default or last used Program)
423 Solo Flute
Secondary Voice
125 Real Vibes
Secondary Voice