User guide

ManualsBrandsKuryakyn ManualsFor motorcycles1659 FIXED MOUNTS FOR MULTI-PURPOSE BACKREST

PAGE

STEP 1

Read and understand all steps in the instructions before starting the installation. Park the motor-

cycle on a hard, level surface and turn off the ignition. Let the engine and exhaust cool.

BIKE PREP:

STEP 2

Remove both saddlebags to expose the saddlebag mounting brackets.

PIC 1. Refer to owners/service manual for proper procedure. Set the sad-

dlebags aside on a soft, sturdy surface.

PRE-ASSEMBLY:

STEP 3

Locate and become familiar with the contents of the hardware kit. Keep the

hardware kit within arms reach of your work area.

STEP 4 Determine the clutch-side (left) Fixed Mount from the brake-side (right).

PIC 2 Set the Fixed Mounts within arms reach of the saddlebag area on the

correct side.

STEP 5 Insert one of the included #10-24 X 7/8” Button Socket Cap Screws

through one of the included #10-24 Lock Washers, and #10-24 Flat Wash-

ers. Set the screw with washers within arms reach of the brake-side saddlebag area.

FIXED MOUNT INSTALLATION:

STEP 6

Refer to PIC 3. Maneuver the front end of the brake-side Fixed Mount underneath the front sad-

dlebag bracket tube (1). Slide the Fixed Mount backward so that the rear “fork” of the Fixed

Mount engages the rear saddlebag bracket tube (2). Rotate the mount upward so the front “fork”

engages the front saddlebag bracket tube (3).

STEP 7

Slide one of the included Thick Washers between the saddlebag bracket and Fixed Mount. Align

the Thick Washer with the hole in the LOWER saddlebag bracket. FIG 1

STEP 8 Holding the Fixed Mount in place, insert the #10-24 screw with washers (from STEP 5) through

the LOWER hole and Thick Washer as shown in FIG 1.

STEP 9

Thread the #10-24 screw into the Fixed Mount weld-nut. Leave loose for now. FIG 1

FIXED MOUNTS FOR MULTI-PURPOSE BACKREST

-cont.-

INSTALLATION

PIC 2

BRAKE-SIDE (RIGHT)

CLUTCH-SIDE (LEFT)

PIC 3

BRAKE-SIDE (RIGHT)

YOU WILL BE WORKING AROUND THE ENGINE

AND EXHAUST SYSTEM DURING INSTALLA-

TION. ENSURE THAT THE ENGINE AND EX-

HAUST SYSTEM HAVE FULLY COOLED TO PRE-

VENT INJURY.

PIC 1

BRAKE-SIDE (RIGHT)

SADDLEBAG BRACKET