Manual

23
APPLICATIONS
Please read this important information!
Intended Use/Use for Intended Purpose
ThedevicesoftheEasyTestsystemarecableandlinendersfordi󰀨erent
purposes.
In each case, a tone sender (ETXX0 – short ET) and a contactless receiver
(PXX0 – also called Probe) are required. The ET feeds a search signal into
a cable/line/wire/wire pair; which kind of cables/lines/wire/wire pairs are sup-
ported depends on the device. Where it is technically possible, work must be
done free of voltage; the maximum allowed voltage is 90 V. In case of elec-
trical cables/lines as part of a electrical installation/system work must always
be carried out free of voltage. The maximum length of the cable/line/wire/wire
pair is 15 km or 9.3 mi (no load).
Through scanning with the Probe, the signal can be found and traced (scan-
ningrange60cmor23.6″).ThesignalismadeaudiblebytheProbe(speak-
er/earphone jack) and visually indicated (LED). Electrical cables, lines, wires
and wire pairs can be found with this method. In addiction, errors and disrup-
tionscanbeidentied.
The devices can be bought individually or as sets (KEX0X) with accessories.
ET300 (D130A) P310 (D130B) KE301 (D130C)
ET400 (D140A) P410 (D140B) KE401 (D140C)
ET500 (D150A) P510 (D150B) KE501 (D150C)
ET720 (D170A) KE701 (D170C)
ET800 (D180A) KE702 (Telekom) (D170D)
KE801 (D180C)
KE801 (Telekom) (D180D)
Recommended sender/receiver combinations (equals sets):
ET300 ET400 ET500 ET720 ET800
P310
1
X (KE301)
P410
1
X (KE401)
X (KE701/
KE702 (Telekom))
X (KE801/
KE801 (Telekom))
P510
1
X (KE501)
Other
sender/receiver combinations are possible in principle but the devices'
individualfunctionswillnotbefullyavailableduetothedi󰀨eringcombination.
¹ Can also be used with the network and LAN cable tester KE7200 for line detection.
See product documentation KE7200.