Product Manual

13
For Model H40B:
Set the throttle lever in the choke position to set the choke. (The throttle lever is located on the
right side of the engine.)
Start engine and move throttle toward slow position to disengage choke.
Slow engine speed and engage mower blades clutch handle. (The clutch handle is located at
the front of the mower under the engine.)
Note: Some belt squealing may occur on engagement. This is normal for a manual clutch
engagement design.
CAUTION: If the mower’s engine happens to quit while in use take care to remove the
wing mower from the uncut area before attempting to engage the clutch. Also inspect the
blades for any obstructions that may prevent blade engagement. Failure to do either may
result in premature belt failure or even a fire.
Adjust engine speed to fast position for full throttle. (The full throttle is located at the detent
position on the throttle control.)
E. SHUTTING OFF WING MOWER
WARNING: Shift to neutral, disengage power to the mower deck, and set the parking
brake before dismounting the tow vehicle.
For Models H60B & C60V:
Set the throttle to slow so the mower blades clutch will disengage.
Allow engine to cool down for a short time before turning the engine off.
Turn off fuel shut off valve which is located on the underside of the gas tank.
For Model H40B:
Slow the engine speed down and disengage the clutch handle.
Allow engine to cool down for a short time before moving the throttle control to the stop position.
Turn off fuel shut off valve which is located on the underside of the gas tank.