Product Manual

4. Position the receiver assemblies in the desired location on the upper actuator mount. Insert
ck
ssembly of Floatation Kit Parts on Electric Lift Kit Models & 44” Models
the four 1/2” x 3-1/2” bolts from the bottom up and place the clamping flat on the top. Secure
5. Insert the caster support assembly into the front receiver assembly and install the wire lock pin.
the wire lo
pin.
the bolts with the lock washer and the nut. Tighten down appropriately to prevent unwanted
loosening.
Note: If the floatation kit is positioned to the same side as the tongue there may be
interference. It may be necessary to relocate the tongue and hitch pivot to the
opposite side.
6. Insert the rear wheel support assembly into the rear receiver assembly and install
Figure 3. A
Receiver Ass
y
.
Caster Support Assy.
Clamping Flat
Upper Actuator
Mount
Wire Lock Pin
1/2” Thick Spacer Plates
(44” Models Only)
Rear Wheel
Support Assy.
4