Product Manual

Note: The actuator can develop 1500 lbs of force. Watch to make sure that when the actuator

cylinder is being lowered for alignment that it does not come in contact with the engine

or other items that could be potentially damaged.

3. Stand back and activate the appropriate “up” switch. Raise the mower to its highest position

and stop. At this time securely tighten the 1/2” x 3” hex head bolts, lock washers and nuts

holding the upper actuator supports in place. This step insures that proper alignment of the

carrier arms has been achieved, which will allow the deck to raise and lower level from side to

side.

Cross Brace

Tube

Actuator Assy.

1/2” x 3” Bolt

Figure 3. Cross Brace Tube Installation

D. INSTALLATION OF THE LIFT CONTROL WIRING ASSEMBLY

1. Using the provided “U” bolts, securely fasten the lift control panel to the tow vehicle. On most

ATVs, the “U” bolts will allow easy installation on the rack.

2. There are two separate electrical cables extending from the lift control panel. There should be

a cable that contains battery clips and another cable that has a connector attached to the end.

Attach the connector side to the actuator connector. Attach the battery clips to the appropriate

terminals on the tow vehicle battery (red attaches to the positive terminal and black to the

negative terminal).

Note: Extra electrical cable length can be purchased (Extension Cable Part #235067) if

needed. In some applications it may be necessary to have extra length to reach the

battery or reposition the lift control panel.