User's Manual
Table Of Contents
- 1. Legal Notices
- 2. Warranty
- 3. Security Summary
- 4. revision history
- 5. INTRODUCTION
- 6. Illustration of Fixture Parts
- 7. Safety Regulations
- 8. Fixture operating environment requirements
- 9. Operation Procedures
- 10. Software interface and error codes
- 11. maintenance
- 12. Consumable part list
- 13. SPARE part list
- 14. fixtures Dismantling and scrapping
KUNSHAN MYZY FIXTURE TECHNOLOGY CO.,LTD
10. SOFTWARE INTERFACE AND ERROR CODES
10.1 Start-up and Standby Interface!
After powering on the unit, the unit self-tests with no abnormalities, then the North Bar
begins to warm up to 50 degrees and the LCD displays as shown below.
10.2 Heating interface!
Insert Hot Pocket module to HDO and read the RFID and identify the correct information on
the hot pocket, North Bar and Hot Pocket will be heated to the preset temperature at the
same time according to the software configuration, the interface will be displayed as follows
( Note: Do not turn the knob at this time, otherwise an E01 error will be reported )
/26 31