Instructions

Contents
© KUNBUS v
Figures
Figure 1: Connection NetTEST II in the cable thread ...... 5
Figure 2: Screen ‘Start-up’ ................................................. 7
Figure 3: Screen ‘Main menu’ ........................................... 8
Figure 4: Screen ‘Test without PLC’ ................................. 9
Figure 5: Screen ‘Segment list’ ........................................ 10
Figure 6: Screen ‘Segment configuration’ ....................... 10
Figure 7: Screen ‘Test with no term’ ............................... 13
Figure 8: Screen after ‘Test with no term’ ....................... 13
Figure 9: Screen after ‘Test with 1 term.' ......................... 16
Figure 10: Screen after ‘Test with 2 term.’ ........................ 18
Figure 11: Screen ‘Generate livelist’ ................................. 19
Figure 12: Screen ‘Slave ident number’ ............................ 20
Figure 13: Screen ‘Slave signal quality’ ............................ 21
Figure 14: Screen ‘Baud rate detection’ ............................ 22
Figure 15: Screen ‘Test protocol’ ...................................... 23
Figure 16: Selection menu ‘Test protocol’ ........................ 23
Figure 17: Screen ‘Test protocol with PLC’ ...................... 24
Figure 18: Screen ‘Test Company’ .................................... 26
Figure 19: Screen ‘User name list’ .................................... 26
Figure 20: Screen ‘Customer list’ ...................................... 27
Figure 21: Screen ‘Plant List’ ............................................ 27
Figure 22: Screen ‘System configuration’ ......................... 28
Figure 23: Screen ‘Device properties’ ............................... 29
Figure 24: Screen ‘License code’ ...................................... 29
Figure 25: Screen ‘Basic parameters’ ................................ 30
Figure 26: Screen ‘GSD - library’ ..................................... 33
Figure 27: Connection Setting via COM1 ......................... 35
Figure 28: Characteristics of the serial interface ................ 36
Figure 29: "Start-up" Screen with the PB-Master .............. 40
Figure 30: Screen ‘Line test’ .............................................. 40
Figure 31: Screen ‘Profibus master mode’......................... 41
Figure 32: Screen ‘Slave line-up’ ...................................... 41
Figure 33: Screen ‘Slave line-up’ ...................................... 42
Figure 34: Screen ‘Extended master’ ................................. 44
Figure 35: Screen ‘Master parameters’ .............................. 44
Figure 36: Screen ‘Other address’ ..................................... 45
Figure 37: Entry mask ‘Master configuration’ ................... 45
Figure 38: Screen ‘Config. with livelist’ ........................... 46
Figure 39: Screen ‘context menu in the Configurator’ ..... 47
Figure 40: Slave –Configuration Dialogue ........................ 48
Figure 41: Screen ‘Receive CFG file’ ................................ 49
Figure 42: Download Configurator -Tool dialogue .......... 50
Figure 43: Confirmation Screen ‘Receive CFG file’ ......... 50
Figure 44: Screen ‘Slave menu’ ......................................... 51