Instructions

Systems with PROFIBUS Master Option
56 © KUNBUS
7.3.1.1 PROFIBUS address
Changing these parameters takes place analogously to editing a
Slave (see chapter 7.2.5.1).
7.3.1.2 General parameters
Changing these parameters takes place analogously to editing a
Slave (see chapter 7.2.5.1).
7.3.1.3 Prm data
Changing these parameters takes place analogously to editing a
Slave (see chapter 7.2.5.1).
7.3.1.4 Cfg data
Changing these parameters takes place analogously to editing a
Slave (see chapter 7.2.5.1).
7.3.1.5 DP tag definitions
Selecting this menu option launches the Tag editing menu).
The user may find further documentation in chapter 7.4 DP.
7.3.2 Line-up
Selecting Line-up will start the DP State Machine in the
NetTEST II for the currently selected Slave.
The PROFIBUS services "SET_PRM_REQ", "CHK_CFG_
REQ" and "SLAVE_DIAG_REQ" continue to be performed in
this case until the result of the "SLAVE_DIAG_REQ" signals
that the Slave is ready for the "DATA_XCHG_REQ".
Thereafter, the "DATA_XCHG_REQ" service is performed
cyclically. If the Slave signals a diagnostic change, the
NetTEST II reads the diagnostic data from the Slave. The
diagnostic data can then be viewed in the ‘Show Slave
diagnostic’ (see chapter 7.3.2.10).
These (cyclic) services are processed by a "background
process", while the system remains responsive on the user side.