Instructions

Systems with PROFIBUS Master Option
52 © KUNBUS
A new Slave address has to be selected in the address selection
menu. Available PROFIBUS addresses are marked with
(+++++).
In order to complete the definition of a new Slave, three more
forms need to be completed.
Each of these dialogues is to be concluded with pressing the
key. If, at any time, the key is pressed, then the creation
process for the Slave is interrupted, and all entries made up to
this point are discarded.
7.2.5.1.2 Parameter
General Slave parameters are to be entered in the first dialogue.
The parameters are needed for all PROFIBUS Slaves. The
Slave name is needed for further referencing within the
NetTEST II. The other parameters are standard parameters for
the Set_Prm_Req and can be retrieved from the appropriate
GSD file (Device Master file).
Figure 46: Entry mask ‘Parameter’
7.2.5.1.3 User prm
The second mask shows the User Param data for the
Set_Prm_Req. The user can enter the size of the User Param
data in the bottom line. By pressing the key the user will
then reach the entries of the (Hex)values. By pressing the
key, the entry mode can be switched from hexadecimal
entry to ASCII entry. The user can return to the hexadecimal
entry by pressing the key. If the data bytes are to be
changed, the numeric entry may be accessed by pressing the
key. This is confirmed by the key.