Instructions

NetTEST II Menu Guide
28 © KUNBUS
5.2.2.9 Segment list
The submenu Segment list has, under Test protocol, the same
task as the menu point under Line test. The functionality is
therefore analogous to the one described in 5.2.1.1.
5.2.3 System configuration
Figure 22: Screen ‘System configuration’
System configuration is for device specific settings, like e.g.
parameterization of the serial interface, time settings, firmware
update and extended parameters. Here, also settings like turn
on / off key signal, automatic switch-off time of the tool,
illumination time for the background illumination of the
screen, and language selection for the screen text.
5.2.3.1 RS232 Interface
The built-in serial interface serves for a data exchange with a
PC. On the PC side, a terminal program is needed. For a data
exchange between NetTEST II and the terminal program (e.g.
Hyper Terminal, Hilgraeve, part of Microsoft operating
systems), the interface parameters like baud rate, number of
data bits, parity, number of stop bits and the used protocol must
coincide. The settings are needed for the menu points 5.2.2.4,
5.2.3.7 as well as 5.2.4.2. For the settings on the PC side,
please see chapter 6.