Instructions

NetTEST II Menu Guide
22 © KUNBUS
5.2.1.8 Baud rate detection
Figure 14: Screen ‘Baud rate detection’
With the menu point Baud rate detection a running bus with
active Master is monitored and the current baud rate is
indicated. During this baud rate scan, the general signal level at
the bus is being measured analogous to Slave signal quality
(see chapter 5.2.1.7). Here the user receives immediately and
without needing an oscilloscope an indication as to existing
reflections at the bus, or if the detected level is too weak. Here,
the level is also indicated in Volt and a status is indicated.

If the Online-Function is activated, the menu Baud rate
detection appears under Test with PLC (see chapter
8.1).