Instructions

NetTEST II Menu Guide

5 NetTEST II Menu Guide

5.1 Start-Up / Setting in Operation

Check the completeness of the scope of delivery and charge

batteries before initial operation. Remove the battery by gently

pressing the locking and at the same time pulling down the

battery placed at the rear lower side of the NetTEST II. Now

place the battery into the charging holder, and check the

loading procedure by means of the LED in the battery charger.

For detailed information refer to the enclosed documentation of

the battery charger. Remove the battery from the charging

holder and push it onto the NetTEST II until you can hear it

snapped in.

Now push the key approximately 1 s, until the PROFIBUS

logo appears on the screen. Then release the key. Besides

the PROFIBUS logo, the firmware version and date appears for

approximately 2 s.

Figure 2: Screen ‘Start-up’

Now the main menu is displayed automatically. The test tool is

ready for operation. With various different text outputs the

display is too small. This will be indicated by "^^" at the right

upper and "vv" at the right lower corner of the text. By pressing

the keys you may scroll up or down in the text.