User manual

Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International BELGIUM.
The pages must be reproduced and folded in order to obtain a
booklet A5 (+/- 148.5 mm width x 210 mm height). When folding,
make sure you keep the good numbering when you turn the pages
of the I/B. Don’t change the page numbering. Keep the language
integrity.
12 TKG FTL 1002 - 160502
Assembly page 12/32
Fax +32 2 359 95 50
AUTOMATIC SWITCH-OFF
The appliance is equipped with a timer. When the timer has counted down to 0, the appliance
produces a bell sound and switches off automatically. To switch off the appliance manually,
turn the timer knob anticlockwise to 0. Note: if you pull out the pan during cooking, the
appliance will be switched off automatically too (the timer will still count down).
BEFORE THE FIRST USE
Before you use the appliance for the first time, please do as follows:
Carefully unpack the appliance and remove all the packaging material and stickers.
Keep the material (plastic bags and cardboard) out of reach of children. Check the
appliance after unpacking for any visible damage, possible from transportation.
Clean the basket and the pan with warm soapy water and a sponge. Note: you can also
clean these parts in the dishwasher.
Wipe the interior and exterior with a damp cloth and dry thoroughly.
This is an air fryer that functions on hot air. Do not fill the pan with oil or frying fat.
Place the appliance on a stable and heat resistant surface.
Place the basket properly in the pan.
Place the pan into the appliance.
NOTE: the pan must be placed correctly, otherwise the appliance doesn’t work!
Plug the appliance into an earthed wall socket.
Do not fill the pan with oil or any other liquid.
Do not place anything on top of the appliance.
Do not put anything on the air inlet on the sides of the appliance, this disrupts the airflow
and has a negative affect to the hot air frying result.
HOT AIR FRYING
The air fryer can prepare a large range of ingredients. See the section SETTINGS for an
indication of the timing and temperature settings.
Check that the voltage in your home corresponds with the voltage printed on the bottom
of the appliance and plug the fryer into an earthed socket.
Carefully pull the pan out of the air fryer by the handle.
Place the ingredients in the basket. Attention: never exceed the recommended amount
or fill the basket over the maximum, as this could affect the quality of the end result.
Slide the pan back into the air fryer properly. Never use the pan without the basket. If the
pan is not placed into the air fryer correctly, the appliance will not function.
Caution: do not touch the pan during and sometime after use, as it gets very hot. Only
hold the pan by the handle.
Turn the temperature knob to the required temperature. An indication of the correct
temperatures can be found in the section SETTINGS.
Determine the required preparation time for the ingredients with the table in the section
SETTINGS.
To switch on the appliance, turn the timer knob to the required preparation time.
Tip: add 3 minutes to the preparation time when the appliance is cold.
If you want to preheat the appliance without ingredients, turn the timer knob to more than
3 minutes and wait until the thermostat light goes out (after aproxx. 3 minutes). Then
remove the pan, fill the basket and turn the timer knob to the required preparation time.
• The on/off control light and the thermostat light go on.
• The timer starts counting down the set preparation time.