User Guide

Kunak AIR Pro – QUICK START GUIDE v.6
P. E. La Muga 9, 4º Ofic. 1, Orcoyen, 31160, Navarra, Spain [phone] [e-mail] www.kunak.es/en 5
The probes or extra sensors can be plugged to the Kunak AIR Pro device in every moment and some of them
depends on the characteristics chosen at the purchase time. The probes will be automatically detected at
start-up of the device. The features of each connector are:
• Connector 1 (M12 x 4 pins type T): Power 7V to 12V.
• Connector 2 (M12 x 4 pins type D):
o K-A3-xx-3: Ethernet PoE.
o K-A3-xx-4: Modbus Slave.
• Connector 3 (M12 x 5 pins type B): Sound Level Meter.
• Connector 4 (M12 x 8 pins type A): Modbus Master & (WBGT or Pyranometer).
• Connector 5 (M12 x 5 pins type A): Anemometer & Rain Gauge.
Figure 3 – Probes position
1.8 Checking Before Deployment
Before placing the base station in the final location, it is recommended to connect the cartridges and probes
to test the correct function of the station in the office.
The steps to properly test the device prior to deployment are described below. The device will be factory
configured being ready to start working.
Video tutorial of the steps described below
Be aware while installing a cartridge or a probe sensor.
• The Kunak AIR device must be powered OFF while plugging/unplugging a cartridge
or probe. If the device is powered ON while doing the change, it can damage the
sensor or the Kunak AIR Pro station. Press firmly on the cartridge.
• Be careful while inserting the cartridges into the device, the pins may bend if the
cartridge is not inserted perpendicularly.
• If a SIM card is going to be installed, please go to “Install or Change the SIM card”
section of the Kunak AIR Pro User Manual.