User Guide
Table Of Contents
- 1. QUICK START GUIDE
- 1.1 Package Content
- 1.2 Required Tools and Equipment
- 1.3 Parts of a Kunak AIR Pro Station
- 1.4 Power On/Off Button
- 1.5 LEDs Indicators and Display Buttons
- 1.6 Installation of the Smart Gas Cartridge
- 1.7 Pluggable Probes or Extra Sensors
- 1.8 Checking Before Deployment
- 1.9 Location Selection
- 1.10 Installation to Mast or Wall Mount
- 1.11 Storage and Transportation
- 1.12 Kunak Cloud Account
- 1.13 Verification of the Correct Functioning
- 1.14 Getting help
Kunak AIR Pro – QUICK START GUIDE v.6
P. E. La Muga 9, 4º Ofic. 1, Orcoyen, 31160, Navarra, Spain +34 848 470 055 info@kunak.es www.kunak.es/en 2
1. QUICK START GUIDE
1.1 Package Content
The Kunak AIR Pro is always supplied mounted into the solar shield and with an eSIM preconfigured to work
with it. To install and configure a SIM card, please refer to the manual on how to change the SIM card.
Gas cartridges, probes and power supplies are sent separately.
Standard Kunak AIR Pro Package:
• 1x Kunak AIR + Solar Shield (more information about
the version on the label of the box)
• 5x Cartridge slot cap (plugged)
• 1x Particle sensor cover kit
1
• 1x Wall or mast mounting kit
• 1x Stainless steel hose clamp
• 1x Allen key 4 mm
• 1x Quick start guide
If any damage has been produced during transport, please, contact KUNAK or your local distributor.
1.2 Required Tools and Equipment
To install the Kunak AIR Pro, you need the following tools:
• 4-mm Allen Key (provided).
• (For mast installation) Screwdriver or 6 mm socket wrench.
• Cutter for the stainless-steel hose clamp.
• (For wall installation) Screwdriver and 4 bolts (minimum 2).
1
Only if the Particle sensor is mounted. If not, the covers will be installed in the device.