User Guide

13
Device Log
The relay supports sending syslog messages to a remote server.
Select Management -> Device Log to manage device log location and contents. Default setting
is that device does not generate logs.
To enable syslog logging:
1. Change Syslog Target to Remote
2. Enter the IP address of the syslog server
3. Set the Severity level as appropriate. It is not recommended to set this any higher than
(5) Informational for regular operation.
Figure 6 - Device Log Settings
Factory Reset
Select Management -> Restore Default to reset Relay back to Factory Default.
Figure 7 - Restore Default Screen
Software Upgrade / Config Backup Restore
Select Management -> Software to update the Relay software. This screen also shows the
current Relay software version.