User Guide

11
Set Heartbeat IP to the IP address of the machine to be pinged
Set Heartbeat enable as appropriate to enable/disable
Finally, select Apply to save the settings. The backhaul connection may be temporarily dropped
while the new settings are applied.
Site Survey / Setup
IMPORTANT: Changing values on this screen will result in the backhaul relaying
re-initializing during which the backhaul connection will be lost.
Select KUMU -> Installation Setting to get to the installation screen as shown in Figure 5
Figure 5 - Installation Screen
This screen is used for antenna alignment. Set UE Mode = Scan Mode and Apply.
Monitor RSRP/RSRQ/CINR while aligning antennas for the best quality signal. Note that in
dynamic environments these may change frequently
Once antennas are aligned, change UE Mode = Normal Mode and Apply.
PCI Lock can be used to lock Donor Cell if necessary. This should only be used when absolutely
necessary as it will prevent the relay from roaming to other cells if the locked cell goes down, or
changes it’s PCI.