Brochure

Weight:
Complete
solenoid: appr. 135 g
Armature: appr. 20 g
Standard:
Voltage: 24 V DC
Flying leads: 10 cm
Thermal stability: E (max. permissible
temperature = 120 °C)
Insulation group
according to: VDE 0110 C 300
Test voltage: 2500 V (eff)
Armature bearing in brass tube.
Force vs. Stroke diagramm F = f (s)
Force measured when operating in horizontal
position, at 90 % rated voltage and with winding at
operating temperature
stroke s = 0 corresponds to armature in
fully home position
Gewicht:
Magnet: ca. 135 g
Anker: ca. 20 g
Standard:
Spannung: 24 V DC
Litze: 10 cm
Thermische
Klasse: E (T
grenz
= 120 °C)
Isolationsgruppe
nach: VDE 0110 C 300
Prüfspannung: 2500 V (eff)
Ankerlagerung im Messingrohr.
Kraft-Weg-Diagramm F = f (s)
Kraft bei waagerechter Bewegungsrichtung und
bei 90 % Nennspannung und betriebswarmer
Wicklung
Hub s = 0 entspricht dem angezogenen,
bestromten Zustand
Umkehr-Hubmagnet
UH
Stoßende und ziehende Ausführung
Two-Directional Linear Solenoid
UH
Thrust and pull type
KUHNKE Magnetkatalog 01/10
86
KUHNKE Solenoid Catalogue 01/10
UH2-L
24 VDC 100%ED
Bestellformel UH 2 L 24 V DC 100 % ED Order specifications
Hubmagnet
Bauart
UH
2
Linear solenoid
Design type
Anschlussart
Nennspannung (Standardspannung)
1)
Litze (Standardlänge 10 cm)
Lötpins
F
L
24
Coil terminals
Flying leads (10 cm standard length)
Nominal voltage (standard voltage)
1)
Soldering pins
Zulässige relative Einschaltdauer bei Luftkühlung (LK) 100 % ED Perm. duty cycle under air cooled conditions (LK)
1)
Die Magnete sind auf Anfrage bis 30 V DC
lieferbar
1)
Other voltages are available on request up to
30 V DC
01234
s/mm
F/N
1
2
3
5
8
100
%ED
100
50
25
15
5
10
20
30
50
80
Zul. rel. Einschaltdauer (ED)
2)
% 100 50 25 15 5 % Perm. duty cycle (ED)
2)
Nennaufnahme P
n
W 8,3 16 30 46 115 W Nominal coil power P
n
2)
Bei Montage auf eine Kühlfläche von mindestens
160 cm
2
ist die 1,3fache ED zulässig
2)
If solenoid is mounted directly onto a flat metal
surface of at least 160 cm
2
, the duty cycle can be
extended up to 1.3 x nominal rating