User Manual

Common Failures and Solutions
1) The display board is working but the motor doesn’t work
Reason Analysis
Solutions
 The break handle is
damaged
Pull out the socket of the break handle (normally open type
brake handle), if the motor works, then it is the failure of break
handle, should replace the break handle.
 The speed regulating
steering handle is
damaged
Firstly check the speed regulating steering handle and motor’s
hall switch are short circuit or not. Generally it is easier to cause
the joint short circuit after rain affected with damp, so notice
the short circuit of steering handle and the motor hall switch.
Otherwise there will be a continuous damage of the
replacement controller!
 The motor is damaged
If the motor doesn’t work turn, please inspect the motor’s hall
switch and turning handle’s signal. Once the power-on, the
controller shall be very hot, generally it is short circuit of the
controller internal power tube, should immediately cut off the
power.
2) Charging doesn’t work
Reason Analysis
Solutions
 The battery charging
port is loose
Change a good charging port
 The connection of the
charger plug is not well
Change a good charger connector
3) Can’t turn on the scooter
Reason Analysis
Solutions
 The battery is dead
Charge the scooter for 1-2 hours according to the user manual.
 The power button is
out of order
Check the power button which has got stuck or not.
Thank you for your reading!