Instruction Manual

13 Installation sound generator
1
2
3
4
5
6
Figure 8: Installation sound generator
Table 6: Installation sound generator - instructions
Nr. Work step Note
1 Route the connecting cable for the sound generator along the tank.
2 Guide the cable further behind the protection plate to the marked opening.
3 Now loosen t h e left , marked screw of the bracket of the middle silencer. 13er
socket
4 At tach the sound generator with the just loosened screw. 13er
socket
5 Connect the connecting cabl e to the sound generator and attach the delivered steel
wire rope to the sound generator as well as to the bracket of the middle silencer.
6 During our test installation, no pushbutton was installed. Choose a suitable po-
sition for the pushbutton, for example at the lower trim panel of the dashboard
of the driver’s side or the center console, drill an appropriate hole and install t he
pushbutton afterwards.
7mm
drill
Kufatec GmbH & Co. KG - Dahlienstr. 15 - 23795 Bad Segeberg - e-mail: [e-mail] 13