Installation Guide

13 Connection ignition lead / ground
1
2
3 4
5
5
Figure 7: Connection ignition lead / ground
Table 5: Connection ignition lead / ground - instructions
Nr. Work step Note
1 Loosen the two marke d screw s of the fuse carri er an d pul l it down. 2xT20
2 Remove the back covering of the fuse carrier by loosening the three snap-fits in all.
3 Place the cable for ignition lead (red/whit e) in the fuse spot 9 and protect this spot
with a 15 ampere fuse afterwards. If this spot is already o c c upi ed , measure with a
mul t i me t er , on which alternative fuse spot you can find ignition l ead and connect it
there.
4 Connect the ground cable (brown) also to the marked ground spot at the bot t om of
the a-pillar on the driver’s side.
1x10er
socket
5 Place the control unit in the dashboard on the beam at the bottom left of the steering
wheel and the module behind the fuse carrier.
Kufatec GmbH & Co. KG - Dahlienstr. 15 - 23795 Bad Segeberg - e-mail: [e-mail] 12