Instruction Manual

15 Cable routing to the sound generator
1
2
2
3
3
Figure 9: Cable routing to the sound generator
Table 7: Instr u ct i ons f or the cable r out i ng to the sound gen er at or
No. Work step Note
1 Open the top for the following steps:
Please route the cable, which comes out of the driver’s footwell, along the sill in th e
direction of the back wall.
2 Route the cable from there to the upper partition by using a push-through-aid and
from that position along the origin cable harnesse through the top opening into the
trunk.
3 Close the top for the following step:
Route the cable to the rear light on the driver’s side and lead the cable throu gh the
pressure compression flap to the outside to the sound generator.
Kufatec GmbH & Co. KG - Dahlienstr. 15 - 23795 Bad Segeberg - e-mail: [e-mail] 15