Instruction Manual

14 Connection Can high + Can low / Ignition plus
1
1
2 3
3
Figure 8: Connection Can high + Can low / Ignition plu s
Table 6: Instr u ct i ons f or the conne ct i on of Can high + Can low / Igni ti on plus
No. Work step Note
1 Connect Can high + low as follows:
Can high (black/white) to pin 6 (orange/black), or according to inscription.
Can low (black/yellow) to pin 14 (or an ge-b rown), or according to inscription. This
port is p osi t i one d on the dri ver’s side.
2 Connect the ground cable with t h e ground pin of the vehicle. The ground pi n is
positioned on the drive r’ s side .
3 Connect the marked cable for igniti on plus (red/white) of the cable harness with
the green cable of the control unit, which is in the red plug, as shown in item 3.
Kufatec GmbH & Co. KG - Dahlienstr. 15 - 23795 Bad Segeberg - e-mail: [e-mail] 14